HD BE Set (EN81-20)

• Up to 16 stops can operate simple and grouped control

• Call lamps and buttons can be connected to the system with only one cable

• All parameters can be easily adjusted with the help of the LCD screen and program buttons on the card

• Password protected programming, PUK code protection against unauthorized use

• Last 16 errors; stop, direction, day and time information can be monitored on the LCD screen

• In standby mode, the duration (day, hour) of the elevator operation after the last maintenance can be monitored on the LCD screen

• Adjustable maintenance period, warning on the LCD screen when the maintenance period is over

• Simple and error-free installation thanks to the internal terminal card, saving on time and control panel terminals

• Overload function

• Short-circuit protected, adjustable display outputs for each stop

• Display outputs can be converted to gray code or binary output

• SA relay contact outputs for direction arrows, out-of-service signal and busy signal; signal partner input for these outputs

• Adjustable parking stop and parking travel time

• Counter bi-stable switch input for position information

• Optionally, moving the car to the first stop when the first power is received

• Warning function on the LCD screen on the card when the door remains open for a long time or when the stop return circuit cannot be detected for a long time

• Adjustable car lamp time, lock waiting time, floor waiting time, maximum high speed time and maximum low speed time

• Door opening signal (AUTO) and selection of the operating mode depending on the direction arrows of this signal

• Manual movement at slow speed using program buttons

• Selection of displaying the first stop the car will go to on the display at each floor change

• Selection of moving the car up to the limit switches or floor level during revision

• Selection of the floor where the fully automatic door is located for elevators with only one fully automatic door

• Electronic phases, phase sequence and PTC (Motor temperature) control, display of errors related to these controls on the LCD screen on the card, deactivation of these functions with parameter selection, adjustment of phase level sensitivity